View Single Post
Old 04-07-2013, 08:11 PM   #3470
Jayrod1318
Poster
 
Jayrod1318's Avatar
 
Joined: Jun 2011
Location: Here and there and stuff.
Oddometer: 1,538
My water cooler rig is seized up on my tig welder. It's been sitting for lots of years unused. I've only used the thing to stick weld a couple times.

I'm not planning on doing any heavy work, so I don't think I need the water cooler. Apparently there is still water in the line because I could strike an arc.

I'm I in danger of screwing something up without the cooler/pump going?

Do I need to swap the torch and lines out with a dry one?


Also, FYI argon co2 mix does not work for Tig. Couldn't figure out why I was burning up tungsten
__________________
Jayrod1318 is online now   Reply With Quote