View Single Post
Old 04-08-2013, 09:01 PM   #6541
Kleio
Adventurer
 
Joined: Jan 2013
Oddometer: 17
Quote:
Originally Posted by Klay View Post
You could use a Dremel tool. Just make sure you don't get any metal dust in the carb...i.e. make sure there's a fuel screw installed to keep the particles out. I put the new jets in two DR200s...one needed the tower ground down a little and on the other, the Kientech screw fit without any grinding. I think I actually just used a file to take down the one that needed it a little.
Thanks again. I feel more confident now. I'll try to install the jet kit this coming weekend. I'll let you know how it turns out.

Regarding the exhaust, I've decided to wait until next winter when I can't ride to send the exhaust to Kientech for the mod. However, if I happen to see an FMF Q4 at a good price in the meantime, I'll get that instead.

Regards.
Kleio is offline   Reply With Quote