View Single Post
Old 05-02-2013, 10:04 PM   #3903
fasteddie23
Adventurer
 
Joined: Mar 2012
Oddometer: 39
Quote:
Originally Posted by MJG2 View Post
Once you remove the evap solenoid on a desmog you have the harness connector to deal with --many guys tape it up or put grease in it.

I was looking for a better way to cap this harness connector

After tons of searching I found a good solution

bmotorsports.com

item conn 10557 male connector and item conn 56059 cavity plug --get a few of the plugs -at least 2

just put in the red cavity plugs and this connector snaps right into the harness for a clean watertight plug
Hey MJ-

I ordered these parts up and they were not plug and play for me. The plug fit into the factory plug/harness but would not snap into place. Is there something I am missing?

Thanks.
fasteddie23 is offline   Reply With Quote