View Single Post
Old 05-03-2013, 08:30 AM   #3907
fasteddie23
Adventurer
 
Joined: Mar 2012
Oddometer: 40
Quote:
Originally Posted by MJG2 View Post
just install the rubber cavity plugs in the round holes where wires would come through - that provides weather seal

then push the new ( male) plug into the bike harness ( female) until the wire clip on that same plug ( female) is past the two tabs on side of male plug

basically snaps in and locks- might need to push hard to seat
I pushed very hard and even trimmed back the top of the male plug to get it to sit higher so it snapped in and no luck...
fasteddie23 is offline   Reply With Quote