View Single Post
Old 06-24-2013, 04:07 AM   #177
kirkster70 OP
moto junkie
 
kirkster70's Avatar
 
Joined: Aug 2008
Location: Virginia
Oddometer: 1,905
Quote:
Originally Posted by phreakingeek View Post
Kirk,

Forgot to mention that the foam used to seal the lid on the toolbox didnt hold up too well. I ended up pulling it out and using some RTV sealant in a 1/8" layer on the entire inside of the lid to create a perfect water tight seal. Still one of the best upgrades done to my bike!!!
Thanks for the heads-up. I put an extra band of al. around the end of this toolbox. Maybe the single layer was too thin and cut into it? I'll try something different next time.
kirkster70 is offline   Reply With Quote