View Single Post
Old 06-27-2013, 08:28 AM   #850
Gnarly Adventurer
photorider's Avatar
Joined: Nov 2008
Location: Southern Utah and Guatemala
Oddometer: 302
DIY Airhead bar risers

I looked for a while for a set of bar risers that would look good on an old Airhead with no luck. Then I remembered that a while back I got a used triple top plate that came with a set of crusty bar clamps and I had an idea...

Pretty happy with the result and my back is thankful on long trips.

As you can see form the pics, I have no fancy tools (not even a vise!) this was done on the kitchen table of my apt. with a hacksaw and some sandpaper. Old cables worked just fine.
photorider is offline   Reply With Quote