Thread: Honda CB500X
View Single Post
Old 08-18-2013, 11:01 AM   #795
Thasiet
n00b
 
Joined: Nov 2011
Oddometer: 9
Quote:
Originally Posted by Lion BR View Post
Adding one inch height from a 19in wheel + one inch suspension travel front and one inch+ on the back should still keep it reasonable in terms of seat height.
Do you believe the damper rod from an NC700X would be interchangeable with the one on this bike? Both are 41mm Showas, and per the parts fiche, many of the fork internals have the same part numbers. This might be a dead nuts simple way to bump the front up to 6.0 inches of travel, especially if one was already going spelunking down there to install a set of cartridge emulators.
Thasiet is offline   Reply With Quote