View Single Post
Old 09-08-2013, 01:26 PM   #13
ramar
Adventurer
 
Joined: Oct 2012
Oddometer: 17
Quote:
Originally Posted by jaumev View Post
Hey Ramar, that's a great work.
Shure you can help me.
Is good to know the Ohlins '52 springs work, I was looking for some advice.

Some questions:

- I'm going to have the Off the Road triple clamp, does the YZ triple clamps have the same geometry than the 660?

- What calliper did you use with the 320mm rotor?

- How is the seat height with this mods? I'm concerning to reach the floor with my 1,78m tall...

Hi Jaumev,

52 Ohlins was a bit short, so I have to put 15mm spacer. The sag is still not what it should be, but it's much better than the stock. I did a lot off road miles and it work great.
About the triple clamp from OTR I don't know, I used from YZ and Tenere steam.
I use original YZ caliper, it work almost as the stock brakes.
About the hight, I am 1.85 and for me is fine but on the edge.
ramar is offline   Reply With Quote