View Single Post
Old 01-18-2014, 11:13 AM   #724
Off Road Ryder OP
Beastly Adventurer
 
Off Road Ryder's Avatar
 
Joined: Mar 2010
Location: Kent Wa
Oddometer: 2,140
Quote:
Originally Posted by ChrisK7 View Post
I set mine up that way. I just used the regular standard wire harness with the switch.
I wired the switch to the blue wire (high beam lead) behind the headlight.
This way I can run the headlights by themselves or flip the switch and now the LED aux lights come on with the high beams only so when I'm on a road with traffic I don't have to hit two switches to dim all the lights, just the regular low beam light switch.
There is quite a bit of wire in the harness so I shortened a few of the wires to clean up the installation under the tank.

There is a little pocket of room on the right side of the frame between the frame and the airbox that I put the relay. I put the fuse under the seat for easy access if needed. I believe there is another fuse near the switch which I located next to the 12v outlet on the left side of the dash. Underneath that outlet there is an access hole which allows you to get to the aux power wires and the fuse for the switch without tearing apart any body panels.

Thanks for posting
For those that go with the skene dimmer package there are no relays, just the small skene dimmer box. and much less wire.
__________________
When Quality matters,Its all about choices.
Cyclops Performance LED Vendors thread
http://advrider.com/forums/showthread.php?t=839163
www.cyclopsadventuresports.com
1-800-624-0278
Off Road Ryder is offline   Reply With Quote