View Single Post
Old 01-01-2009, 10:52 AM   #4
rexbro OP
Gnarly Adventurer
 
Joined: Aug 2008
Location: SE PA
Oddometer: 145
Remove the single screw from the mount and swing it out of the way then remove the CF card. Next loosen the 6 screws holding the case together. A #0 Phillips screwdriver works well for this.



Gently pry apart cases with small flat bladed screwdriver. Cases should come apart with just a slight amount of pressure. Be careful that the case seal does not get damaged. Remove the 2 screws holding the board to the back case. There are no wires attaching the board to the case.



Be careful not to bend the 6 little tabs on the board when handling it. They are the contacts that touch the main board when the case is assembled.



This is the broken solder connection that I found.



Figured I would try to fix it myself since I'm cheap and ride a KLR too.
rexbro is offline   Reply With Quote