View Single Post
Old 02-05-2009, 12:39 AM   #6
DRjoe OP
Beastly Adventurer
DRjoe's Avatar
Joined: Sep 2007
Location: Sunshine coast qld
Oddometer: 5,211
Originally Posted by LukasM
Sounds like an awesome idea! Great minds think alike.

What do you have in mind for the bash plate, can you weld and bend thick aluminum? What kind of rally fairing? Frame mounted? What are you going to model it off?
Your story inspired me to pull my finger out mate.

I'm going to make an ally frame to hold the fairing not sure what the design will be i'll just go with the flow and see what i end up with.

Here is the bash plate
Its mostly made from 3mm ally but there are also some 4mm ribs on the inside to give it some strength

here are a few bad pics of the un finished item

DRjoe is offline   Reply With Quote