View Single Post
Old 02-21-2009, 09:48 PM   #3
Hodakaguy OP
NorthWest Adventure Rider
Hodakaguy's Avatar
Joined: Jul 2007
Location: Eastern WA State
Oddometer: 2,097
Originally Posted by jesusgatos
Right on. Are the sheetmetal parts laser or water-jet cut, or hand-cut? Just wondering...
The whole assy is hand built. I built the first one and got it just where I want it, then I built a jig so I can replicate them the exact same each time. I made a couple other small jig/tools to get the cuts and bends in the flat bar ect.

NV 2012 - In Memory of the Crewmen RR: CLICK HERE
Adventure Is Out There - NV RR: CLICK HERE
Riding Through History - NV RR: CLICK HERE
And Then There Were Four - OR RR: CLICK HERE
My VW Syncro Westy Build Thread: CLICK HERE
Hodakaguy is offline   Reply With Quote