Thread: KLR250 thread
View Single Post
Old 03-30-2009, 07:03 AM   #13
aka "Canadian Karl"
KWC's Avatar
Joined: Jan 2004
Location: Illinois, "come for the corn, stay for the beans"
Oddometer: 897
new to me KLR250, 1988

....came with a 50 tooth rear sprocket, i suspect for a little more grunt on the bottom end from the stock 44t, i'd like to either replace just with same or get a complete stock set (front, chain, rear), just so you know, the bike is to be fixed up and sold as i already have too many bikes, so the gear ratio doesn't bother me much, anyone know a good vendor for the 50t rear or a good reasonably priced stock set, used is fine as long as minimal wear? i can't find the 50t listed anywhere for the KLR 250 so i suspect it is a KLX 250 sprocket, anyone know if these two bikes have intechangeable rear sprockets?

also looking for some other bits for this bike, as in my thread in "parts"

my critical needs are a straight (non-lowered) sidestand and the fork boots


"Whisky is manís best friend...whisky is a bottled dog".

Vinicius de Moraes
KWC is offline   Reply With Quote