View Single Post
Old 04-08-2009, 05:53 PM   #85
Riding NC
NCStephen's Avatar
Joined: Oct 2008
Location: Hillsborough NC
Oddometer: 3,097
well got my tech project done. The only issue was one of the forum showed it being done and the guy left the wheel in place. Clymers had the wheel off. What was missed in the write up with the wheel on process was you can't get the caliper off the rotor. So it requires a little more maneuvering to get the old pads out and new pads back in between the pistons and rotor. But it was done. I do think that if you knew what you doing it would only take 15 min.

Upon restart, the abs light flashed a lot longer than usual and I held my breath. It then reset and was fine. With the rear brake linked to the front brakes I don't often use it singlarly. Still in testing it, it did feel a lot better!.


Anders, how did yours turn out?
03 BMW K1200 RS
03 Honda RC51
74 Honda CB750 K4
76 Pillion Rider Ver 1.0
Give a holler, get a smile.
NCStephen is offline   Reply With Quote