1977 CT90 rotor bolt

Old Nubbins · 07-19-2010, 11:32 AM

Does anyone know the diameter and pitch (i.e. M8 x 1, M8 x 1.25 or M6 x 1) of the bolt that fastens the alternator rotor to the crankshaft? I buggered up the threads and am at work today and can pick up the appropriate tap if I knew which one it was.

Thanks!

PinkSteel · 07-19-2010, 05:43 PM

Probably too late, but ask your question on the Yahoo Groups CT90 board.

Hundreds of tiddler gear-heads who are very knowledgeable and helpful.

Good luck.

Old Nubbins · 07-19-2010, 06:10 PM

Thanks for the pointer. Turns out it is M8 x 1.25, in case anyone was wondering, you know, 'cause this thread is just burning up the forums right now

07-19-2010, 11:32 AM	#1
Old Nubbins ^OP Gnarly Adventurer Joined: Feb 2009 Location: Darrington, WA Oddometer: 434	1977 CT90 rotor bolt Does anyone know the diameter and pitch (i.e. M8 x 1, M8 x 1.25 or M6 x 1) of the bolt that fastens the alternator rotor to the crankshaft? I buggered up the threads and am at work today and can pick up the appropriate tap if I knew which one it was. Thanks!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: .
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-19-2010, 05:43 PM	#2
PinkSteel Gnarly Adventurer Joined: May 2009 Location: Fairfield County, CT Oddometer: 205	Probably too late, but ask your question on the Yahoo Groups CT90 board. Hundreds of tiddler gear-heads who are very knowledgeable and helpful. Good luck.

07-19-2010, 06:10 PM	#3
Old Nubbins ^OP Gnarly Adventurer Joined: Feb 2009 Location: Darrington, WA Oddometer: 434	Thanks for the pointer. Turns out it is M8 x 1.25, in case anyone was wondering, you know, 'cause this thread is just burning up the forums right now