ADVrider

Go Back   ADVrider > Bikes > Some Assembly Required
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-15-2012, 06:11 AM   #16
CharlieT OP
old school
 
CharlieT's Avatar
 
Joined: Jan 2006
Location: Kalamazoo
Oddometer: 1,628
Might as well get around to finishing the thread off. Pretty much all that was left to do was the painting and detailing. Headed down to the local NAPA store with the paint supplies. Thumbed thru some of their books and settled on a red and a silver that looked pretty close to the original colors. Both happened to be from early-mid-90's Ford Trucks!!

tubing, mounts all painted black and fairing back on



btw, all the tubing for the fairing and for the frame stiffeners etc., were made using this old homemade tubing bender. No fancy equipment here.


The red and silver came out as a pretty good match to the original colors.


The numer plate back grounds are from plain large rectangular sheets of number plate vinyl. TO get the round shape and size.....just stuck a dinner plate on the sheet and traced around it.....a number *plate*!!
__________________
A good bike mechanic only needs two tools, WD40 and duct tape. If it doesn't move, but should, use the WD40. If it does move but shouldn't use the duct tape.

http://www.facebook.com/pages/Checke...22319847810910
CharlieT is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 03:19 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014