ADVrider

Go Back   ADVrider > Gear > The Garage
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 10-08-2012, 09:38 AM   #1
Ceemack OP
Adventurer
 
Joined: Jan 2011
Oddometer: 76
Prevent stuck wheel bearings?

After a considerable struggle, I've finally gotten the old bearings out of my front hub so I can install fresh ones. The old ones were stuck so badly I had to cut them with a Dremel tool before the could be pounded out.

I'll have to replace these bearings again someday, so I'm trying to think of ways I could make it a bit easier.

Is there any reason not to spread a tiny amount of grease or anti-seize around the outside of the new bearings before they're installed?
Ceemack is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 02:56 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014