ADVrider

Go Back   ADVrider > Bikes > Some Assembly Required
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 10-27-2012, 05:05 PM   #11
jdrocks OP
Gravel Runner
 
Joined: Jul 2007
Oddometer: 3,855
when i said the OEM fender assembly isn't up to the pounding it gets on rough gravel roads, here's why.

the left and right seat covers are connected to the tail light with plastic dowel tabs that slide into rubber grommets on each side of the tail light. these eventually shear off because the assembly flexes too much.



the dowels are supposed to slide into these grommets.



when the dowels break, pairs of plastic tabs on the bottom of the seat covers have to carry more load, and eventually these break too.

broken tab on the seat cover



all the plastic pieces around the tail light have to be securely anchored so that the plastic trim piece over the top of the tail light aligns with it's own tabs, impossible with all the other broken tabs and dowels.



so the dowels break, the tabs break, the trim won't fit, and the whole freakin' mess starts lookin' like it's going to crack in half after just one more rough road.

time for something new.
jdrocks is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 06:44 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014