ADVrider

Go Back   ADVrider > Bikes > Hacks
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 02-21-2013, 08:53 PM   #1
Nano0k OP
n00b
 
Joined: Feb 2013
Oddometer: 7
First Projet

Hi , first post , nice to meet you all !
After being a while looking up for some swing arm configuration over many site i decide to show you my work wondering if my setup enough strong. nothing full welded so i can dissemble it before making a bad move.

im used to speak french so ill try my best to describe this set up. mainly a 1 5/8 tubing 3/6 wall ( ~ L.20 inch ) welded on a pivot point ( L. 4 inch ) which got 2 radial bearing each side. fully machined wheel shaft welded on a 4.5in triangle. ( easier to change on a shaft break ) main frame is 1 1/4 tubing. everything work fine when wheel goes up and down. but is it gonna be able to handle side movement effect ?

Nano0k is offline   Reply With Quote
 

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 07:48 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014