ADVrider

Go Back   ADVrider > Gear > The Garage
User Name
Password
Register Inmates Photos Site Rules Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
Old 04-21-2013, 10:37 PM   #61
troidus
Beastly Adventurer
 
Joined: Sep 2010
Oddometer: 12,572
Quote:
Originally Posted by drtdino View Post
Quote:
Originally Posted by Jack90210 View Post
Those wires really need to have some kind of wear liner over the top of them. A rubber grommet for the holes wouldn't hurt, either.
The way that's set up, there's really no good way to keep the wires from being pinched or chafed. I'd drill holes on the inboard side of the rails on both the fixed and moving portions (assuming the frame rails are fully boxed) and route the wires through the new holes, using grommets at the holes and covering the wires with flexible conduit or heavy-gauge heatshrink. If the rails are open channel, then just put the wires in flexible conduit and secure the conduit to the rails at both ends to keep it from flopping around.
troidus is offline   Reply With Quote
Reply

Share

Thread Tools Search this Thread
Search this Thread:

.
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


Times are GMT -7.   It's 08:46 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright ADVrider 2011-2014