Hi all, I've recently purchased a 2003 LC4 640 SuperPrestige and am trying to sort out some issues, but am having not much luck. I'm based in Japan and although we do have some decent KTM shops here, they usually charge out the wazoo just to look at the bike, so I wanted to diagnose any issues before having them take a look. 1) When I start the engine using the e-start, sometimes I heard two or three loud "clacks" or "clunks", this also happens when I start the engine after a short shutoff period and restart when the engine is hot. (Like after a short shopping run, pop in and pop out of the store). Is this normal or is it a sign of a more serious engine issue about to happen? *UPDATE: read through this: http://www.advrider.com/forums/showthread.php?t=222515 and am REALLY, REALLY hoping this is not the problem but it sounds like it is....jeez. Going to try and hit up the local KTM guys for the correct seal or find SKF Seal # 19993 on the 'net here. 2) The brake light doesn't brighten when I pull the front or the rear brake. I looked at the bulb, one of the contacts was looking pretty bad, so I replaced the bulb, but still not working. The bulb lights up no problem along with the blinkers and the headlights, but I cannot fathom why it won't brighten when pulling on the brakes. Besides being a safety issue (not wanting to get rear-ended), I also don't want a ticket.... 3) Stalling like crazy. Maybe it's because I am more used to riding 4-stroke 250's and 1200 cc streetbikes before I got this thumper, I am always expecting it to pull away in low revs with no problem, but the engine will cut out. I have read through this thread: http://www.advrider.com/forums/showthread.php?t=37721 and have gleaned that all I have to do is cut the clutch switch wires, solder them together and tuck it under the triple correct? I'm assuming the same goes for the side-stand switch. (cut, solder, tuck it away). Thank you for reading and any help would be much appreciated. Regards, W.