Drive shaft

Discussion in 'Airheads' started by kellymac530, Nov 1, 2012.

  1. kellymac530

    kellymac530 motorcycle addict

    Joined:
    Feb 4, 2010
    Oddometer:
    1,052
    Location:
    so. cal.
    I am looking at extending a swing arm on an R80G/S and I want to do the method of using 2 drive shafts with one weld rather than a splice with 2 welds.

    Are the U-joint ends on all R60 R80 R90 R100 driveshafts the same size?

    I have a line on a couple of shafts and don't want to waste my money if the U-joints are different
    #1
  2. kellymac530

    kellymac530 motorcycle addict

    Joined:
    Feb 4, 2010
    Oddometer:
    1,052
    Location:
    so. cal.
    Is it also the same U-joint end on a /2?
    #2