Separate names with a comma.
Discussion in 'Crazy-Awesome almost Dakar racers (950/990cc)' started by unaweep, Dec 19, 2013.
Found on the garage floor in the vicinity of a Super Enduro.
Thanks for any tips!
Similar to the tank holder caps but not seen anything like that on Maya, are they orings on the sleeved part
Is your bike running or in bits?
To me it looks like a mounting spacer off a shock absorber or some other high grade part.
Let's see the other side...
front wheel spacer? lets see the other side.
I was going to say that.
But then I didn't
Thanks guys- way too small to be a wheel spacer.
Yes, there is an O-ring on it. No, the bike isn't in pieces, thank goodness!
It runs really well.
I'll try to get a better pic and post again. Appreciate the input!
You going to Phx after Christmas with the crew?
Rear brake lever bushing?
Not sure where it goes, but it looks like one of those retainers for a countersunk SHCS, like the bolts that hold the rear subframe on. I don't remember seeing anything like that on my ADV, though.
Sell the bike now...for cheap.
It will cost ya nothing but money.
I can help out
Oring would indicate its designed to hold back a fluid of some sort or just stay retained in place. Hole in the center looks like a shaft or push rod might pass through it. I've never had a bike apart to see that piece yet but did you do anything with the clutch push rod from the slave cylinder through to the basket?
Pure speculation here.
The other obvious answer is its not from a bike. Just fell off your shelf and rolled over for a better look at the orange candy.
I haven't done any of that work. I think you may be right- It jumped off the bench to check out the big Katoom and probably doesn't belong to the SE. Thanks for the help!
Blinker shaft seal.
They all do that.
Explains why I'm always low on blinker fluid.