Gen 1 KLR 650 - Clutch Safety Switch - Where to Ground Green Wire?

Discussion in 'Thumpers' started by JuniorScout, Mar 29, 2019.

  1. JuniorScout

    JuniorScout Adventurer

    Joined:
    Jun 8, 2009
    Oddometer:
    19
    Location:
    Spokane, WA
    I know this topic has been beat to death, but I have scoured the internet and cannot find the precise answer I need. So:

    I want to completely and irreversibly remove the clutch safety switch, including all the wiring running up the handlebar. I don't want to ever see these wires again, and I want a clean handlebar.

    I understand that I need to connect/jump/solder/[insert preferred connector here] the two striped wires. No biggy, that's easy. It's the exact same as the side stand switch, which I have already done.

    My question is, what do I do with the light green wire? Do I just cut it off near the instrument panel and leave it dangling? Do I tape it to the frame? Do I connect it to the striped wires? What do I do with it?

    Please don't send me a link to MarkNet. That site is exceptionally helpful, but does not answer this question.

    Thank you!
    #1