Ordered the 10, but it didn't have a earphone jack, so sent it back and ordered a 50s. Hopefully this will sync reliably with my SR10. One of my CB groups indicat they will probably be switching to Sena 50s after this years ride. I bet my GWRRA groups switch in a couple of years. Until then, I'll have my Midland and SR10!
Experienced a strange phenomenon today. It was easily repeatable, so perhaps something in the software? Anyway when using headphones, then using Google, as sound returns to the previous function (music) volume of the music is very high for a few seconds until the unit realizes it should be lower and takes it down.
Got mine on Friday, did all the updates (we got 4 of them) Tried out today, worked well, but, my buddies have not installed yet, so did not get to try out mesh. Sound was about the same for me, coming from a 20s.
Has anyone had any luck with Sena voice commands? I’ve not been able to get any recognized whatsoever. I confirmed when u was updating the firmware today that the voice command function was enabled. I also know the mic works, as I’ve had phone conversations, and can also activate Siri by voice. No luck, though, with Sena voice commands, not even in the house.
Could you tell me if you have problems with signal drop using this controller. I have been using a Chubby button and at first it seem ok but now it seems to be dropping the signal a heck of a lot and the two units are only about 12-18" apart.