Separate names with a comma.
Discussion in 'Battle Scooters' started by Photog, Dec 1, 2012.
WTB Tupperware for a 2011 Honda PCX.
2020 Honda Super Cub
Thanks. I've since purchased my 4th ebike, which cost almost as much. Sellers price for the used Super Cub is almost 400.00 over MSRP for a 2020, so that bike might be for sale for a while.
Did you look at buying new? The panels are surprisingly not that bad from revzilla (or similar online stores).
I bought the scooter used and odds are that it might get crashed again during a new riders first few outings. I just ordered a few used non color matching pieces off Ebay. She has done great so far, I dropped it while holding it for her.
I’m not riding my big scoot enough. So I’m going to pass it on to the next person.
2009 Kymco People 150 17k km showing, runs like a top. Various scratches and scuffs from teaching the wife. Slightly bent levers. Added D rings to tie down bags. Givi trunk.
More pics available on request
Located in SW VA
Wanted to Test Ride
Talk about a shot in the dark: I'm looking for a Yamaha Xmax 300 to ride just to see if it fits me with my riding gear on. None of the dealers within 150 miles of me I have contacted have the bike and none have any intention of ordering one unless I sign a contract and put a deposit down. I will pay $100 to take the bike on an under 20 mile test ride from Montpelier, VT to Worcester, VT on VT Route 12 and back to Montpelier. Just south of Worcester the road is as bumpy as a paved road gets around here. After the self isolating ends around here of course. PM me for my location and contact info.
Found- Vespa 300 GTS
Found a Vespa 300 GTS, Max $3500
Within 500 miles of Charlotte NC
WTB- exhaust shield and seat for 2007 Honda Reflex Scooter. It’s the rear shield cover, PO was a bonehead and just broke stuff off and left it laying in the street.
I'm looking for a scooter with a blown motor near CT.
A have a Minarelli 50 from a 2003 Vino that my buddy crashed. It's my daughters bike.
Nothing Chinese, thank you.
I guess it'll fit lots of scoots - Yamaha, Buddies, etc.
Would love to fab some mounts and stuff it into a Ruckus but they're hard to come by up here.
WTT: I have about 3/4 of a Piaggio Master 500 engine from a 2006 BV500. It had about 13,500 on it and when I got it, it had a bad bushing in the small end of the con rode. It ran but it rapped. When I got the head and cylinder off the piston was free to rock side to side, a lot. Rather than tear it all down and find a replacement crankshaft, I got a used replacement engine. This one has no starter, no alternator side cover, and no driveline. The piston is bad. There are no known issues with the crankshaft except the con rod issue.
I'm in Oakland, CA, and not interested in shipping the thing. If you have a scooter project to swap, nearby, send me a PM. Or whatever. No cars, nothing very big. If you need a picture of something, let me know.
Looking for a scoot near South Carolina. Bigger cc preferred, sub $1k. I’ll need to ride it back so that’ll be a factor
Good luck with that.
Test ride has been accomplished, many thanks to