Separate names with a comma.
Discussion in 'Thumpers' started by gjcarving, Nov 23, 2013.
Tuu scary. I don’t want to split it.
It has KTM specific fittings.
It came out a bit. I was scared I was going to melt a hole through it.
Just hide it with a carbon fibre pipe guard. Or go full hipster and header wrap it. Its not hurting your power.
Ive done Ti Husky (Italy) and KTM SXF505 headers, thin as paper. Fill with water within about 1” of either end of the dent and put the dent in the lowest point while freezing. Check it every couple hours. And thaw and refreeze often.
It is stupid effective. That looks like an easy won to pop oot.
Elllll pipes look like that at idle, yule be fine.
Thee ice scares yah???
I was going tew suggest that but I didn’t want tou accept any liabilities..
Really, I was.
That's an interesting accessory port in your floor.
It is in the freezer. If it splits, I’ll be learning how to weld TI.